Does new fire hose need to be tested?

If the hose is repaired, or the couplings are repaired or replaced, the hose shall be service tested in accordance with Section 4.8 before being placed back in service.

How do you test a fire hose?

With the test cap open, the pressure shall be raised gradually to 45 +/- 5 psi allowing all air to be removed from the system. Close the test cap slowly as well as the outlet water supply valve. Secure the hose directly behind the test cap to avoid whipping or other uncontrolled reacting in the event of a hose burst.

How often should fire hose be service tested?

Any pre-connected fire fighting hose (e.g. booster hose, bumper turrets) on a fire apparatus must be system tested annually.

What is the NFPA Standard for fire hose?

NFPA 1962: Standard for the Care, Use, Inspection, Service Testing, and Replacement of Fire Hose, Couplings, Nozzles, and Fire Hose Appliances.

What is the life expectancy of a fire hose?

Taking care of a fire hose the “prescribed” way can lead to a useful life of 10–20 years. More vigorous use will cut down on the lifespan of course, but good fire hose care can still go a long way in keeping your hoses working at maximum efficiency for a longer length of time.

Does fire hose expire?

At present, so long as your hoses pass inspection, there is no maximum life span, but common sense tells us that their materials will degrade over time. If you see obvious signs of wear in the folded or coiled areas, or where the hose connects to the fittings, it is time to consider replacement of the hose.

When should fire hose be replaced?

NFPA 25, Chapter 6, table 6.1. 1.2 states that fire hoses should be tested every 5/3 years, and they should be pressure-tested annually, in accordance with NFPA 1962 , Care, Use, Inspection, Service Testing, and Replacement of Fire Hose, Couplings, Nozzles, and Fire Hose Appliances revised in 2013.

What is the life span of fire hose?

How do you maintain a fire hose?

Unroll the fire hose on a clean surface and gently stretch it out to remove any kinks. Thoroughly brush any dirt off of the hose using a clean dry brush with soft or medium bristles. Refrain from using a hard-bristled brush, power washer, or solvent when cleaning the hose, as doing so may damage its outer jacket.

How do you dry a fire hose?

For hose covered with rubber, nitrile, or another protective exterior, wipe the hose dry. Other hose types can dry on a tower or rack. If using a commercial hose dryer, ensure that the inside of the hose drains completely. Avoid drying hose in direct sunlight or on hot pavement.

When should you replace fire hose?