How do I reset my HP ProCurve 2824 to factory settings?

How do I reset my HP ProCurve 2824 to factory settings?

To execute the factory default reset on the switch, perform these steps:

  1. Using pointed objects, simultaneously press both the Reset and Clear buttons on the front of the switch.
  2. Continue to press the Clear button while releasing the Reset button.
  3. When the Self Test LED begins to blink, release the Clear button.

How do I reset my HP switch password?

If you lose or have forgotten a switch password: Solution: You can clear the switch password by pressing the recessed Clear button on the front of the switch. This action deletes all password and user name protection from all of the switch’s interfaces.

How do I log into my HP switch?

To enable web login, log in to the device via the console port, and perform the following configuration: • Enable HTTP or HTTPS service • Configure the IP address of the VLAN interface • Configure a username and password The device supports the following web login methods: • HTTP login: • HTTPS login: The following …

How do I reset my HP V1910 password?

HP V1910-48G JE009A Factory reset – Password recovery capability enabled.

  1. Connect switch cable to COM.
  2. Open Putty on COM 38400 – 8 – 1 – N.
  3. Powercycle the switch.
  4. Press Ctrl-B at boot to enter extended boot menu.
  5. Skip current system configuration.
  6. Reboot.

How do I reset my HP 8g 1920?

Restoring to factory defaults

  1. Using a small, thin tool with blunt ends (such as a paper clip), press the Reset button on the front of the switch.
  2. Continue to press the Reset button until the Fault LED light begins to flash.
  3. Release the Reset button.

How do I turn off password recovery capability?

Password recovery capability is enabled. To perform this operation, first disable the password recovery capability using the undo password-recovery enable command in CLI. If password recovery capability is disabled, enter Y at the prompt to complete the task.

Is there a default password for HP ProCurve switch 2824?

Re: Default Password HP Procurve Switch 2824. NO default password is set when the switch is new. One default Vlan (Vlan1) with IP DHCP enabled on this Vlan, and it has 2 users built in: Manager & Operator with NO password set but you can configure other user names (Optional).

How to set default user name and password in 2824?

Re: 2824 switch factory default user name & password. NO default password is set when the switch is new. The default configuration is quit simple: One default Vlan (Vlan1) with IP DHCP enabled on this Vlan, and it has 2 users built in: Manager & Operator with NO password set but you can configure other user names (Optional).

Which is the default password for HP switch?

What HP do not tell you is that once the Swith is configured via the CLI with a new password when you login to the switch via the web interface the default username for the HP 2920-24G is manager.

Which is the default username for HP 2920-24g?

What HP do not tell you is that once the Swith is configured via the CLI with a new password when you login to the switch via the web interface the default username for the HP 2920-24G is manager. Hope this helps someone in future.